37mm Loading

2 Inch Plastic Hull

37mm yellow hulls

Price: $2.00

High Impact 37mm plastic hulls. Uses a 209 shotgun primer for ignition.

2 Inch Aluminum Hull

2in aluminum hulls

Price: $9.99

Super strong NEW UN-FIRED 2 inch 37mm aluminum hulls. Uses a 209 shotgun primer for ignition. Designed for black powder loads or black powder substitutes (no smokeless powder). They have a wall thickness of .076 inches and a double reinforced lip around the bottom of the wall where the powder is loaded. The bottom is .25 inches thick. In our opinion, these hulls are heavier duty, longer lasting and thicker than the used military hulls we have seen and tested. Manufactured by American Specialty Ammo

3 Inch Aluminum Hull

3in aluminum hulls

Price: $12.99

Super strong NEW UN-FIRED 3 inch 37mm aluminum hulls. Uses a 209 shotgun primer for ignition. Designed for black powder loads or black powder substitutes (no smokeless powder). They have a wall thickness of .076 inches and a double reinforced lip around the bottom of the wall where the powder is loaded. The bottom is .25 inches thick. In our opinion, these hulls are heavier duty, longer lasting and thicker than the used military hulls we have seen and tested. Manufactured by American Specialty Ammo

5 Inch Aluminum Hull

5 in aluminum hulls

Price: $15.99

Super strong NEW UN-FIRED 5 inch 37mm aluminum hulls. Uses a 209 shotgun primer for ignition. Designed for black powder loads or black powder substitutes (no smokeless powder). Great for extra velocity for our smoke kits!!

2 Inch Anodized Aluminum Hull - Blue

2 inch anodized aluminum hulls

Price: $14.99

Super strong NEW UNFIRED 2 inch 37mm aluminum hulls. Uses a 209 shotgun primer for ignition. Designed for black powder loads or black powder substitutes (no smokeless powder). Hard coat anodized blue. They look great, clean up easier and the finish lasts longer!

3 Inch Anodized Aluminum Hull - Blue

3 in anodized aluminum hulls

Price: $17.99

Super strong NEW UNFIRED 3 inch 37mm aluminum hulls. Uses a 209 shotgun primer for ignition. Designed for black powder loads or black powder substitutes (no smokeless powder). Hard coat anodized blue. They look great, clean up easier and the finish lasts longer!

37mm "Bird Banger" Builder Kit

37mm Bird Banger Builder Kit

Price: $39.99 / $74.99 / $165.99

Contains 37mm plastic hulls, paper tubes, plugs (with hole), plugs (solid), rubber bands, paper end cap (with hole), waterproof fuse and instruction sheet. Available in 10, 20 and 50 round quantities. 

37mm "Bird Banger" Builder Refill Kit

37mm Bird Banger Refill Kit

Price: $28.99 / $55.99 / $125.99

Contains enough 37mm paper tubes, plugs (with hole), plugs (solid), paper end cap (with hole), waterproof fuse

37mm Smoke Bomb Builder Kit

37mm Smoke Bomb Builder Kit

Price: $24.99

This kit contains everything you need to construct smoke bomb projectiles for our plastic or aluminum 37mm hulls. Kit contains 10 each of: fused tube projectiles, cardboard wads, payload caps and detailed instructions with pictures. You will also need to order of of our three styles of 37mm hulls. Hulls and smoke mix sold separately. 

37mm Firework Projectile Builder Kit

37mm Firework Projectile Kit

Price: $34.99

This kit contains everything you need to make ten 37mm firework projectiles. Contains 10 large fused payload cups, thirty feet of flying fish fuse (three ten foot pieces each a different color), 10 rubber bands and instructions on constructing your projectiles. These special fuse types are to be cut into one inch lengths and will act identical to firework starts. It creates a bright burst of color similar to a firework mortar shell. 

This can only be used with our aluminum cases. Cases sold separately. 

37mm Payload Cup

37mm Payload Cup

Price: $2.00

This payload cup works with our aluminum cases. It holds your payload similar to a shotgun wad. You will need the powder bushings to use this product. The cup sits on top of the bushing. 


Constructing, possessing and/or using anti-personnel rounds with an unregistered Launcher is prohibited by federal law. Before you construct, posses and/use any anti-personnel rounds, you must first register your launcher with the ATF and pay the appropriate tax. 

37mm Fused Payload Cup

Price: $2.50

This fused payload cup can be used to make homemade smoke rounds and pepper gas rounds. There is fuse molded into the plastic. There is very little time delay. The large cup can be used with our 2 or 3 inch aluminum hulls. The small cup can only be used in the 2 inch aluminum hull. 


Constructing, possessing and/or using anti-personnel rounds with an unregistered Launcher is prohibited by federal law. Before you construct, posses and/use any anti-personnel rounds, you must first register your launcher with the ATF and pay the appropriate tax.   

37mm Powder Bushing

Price: $.75

This bushing sits on the bottom of our aluminum cases. It will need to be rubber cemented or hot glued to the bottom. You will get several shots out of each one. The bushing holds the powder directly over the primer for maximum efficiency. When filled to the top it hold 75-80 grains of fff black powder (or black powder substitute).


Constructing, possessing and/or using anti-personnel rounds with an unregistered Launcher is prohibited by federal law. Before you construct, posses and/use any anti-personnel rounds, you must first register your launcher with the ATF and pay the appropriate tax.     

37mm Rounded Plastic Cap

Price: $.50

Rounded payload caps. Injection molded for precise fit. 


Constructing, possessing and/or using anti-personnel rounds with an unregistered Launcher is prohibited by federal law. Before you construct, posses and/use any anti-personnel rounds, you must first register your launcher with the ATF and pay the appropriate tax.       

37mm Flat Plastic Cap

37mm Flat Plastic Cap

Price: $.50

This cap has multiple uses. You can use it to seal the top of the fused payload cup for smoke/pyrotechnic rounds or flip it over and it caps the payload cup for dispersal type rounds.   

 

Constructing, possessing and/or using anti-personnel rounds with an unregistered Launcher is prohibited by federal law. Before you construct, posses and/use any anti-personnel rounds, you must first register your launcher with the ATF and pay the appropriate tax.     

37mm Loading Starter Kit I

37mm Loading Starter Kit

Price: $119.99

This kit contains five 2 inch aluminum hulls (upgrade to 3" hulls for $15), 5 powder bushings, five small payload cups, five large fused payload cups, ten payload lids, 37mm bird banger builder kit with 10 plastic 37mm hulls, 100 209 shotgun primers, waterproof cannon fuse and a free 37mm load data booklet. 

Check federal, state and local laws and regulations before constructing any 37mm cartridges. Buyer assumes all risk involved in loaded, reloading constructing and using 37mm cartridges. 

37mm Loading Starter Kit II

37mm Loading Starter Kit II

Price: $189.99

This kit contains ten 2 inch aluminum hulls (upgrade to 3" hulls for $30), 10 powder bushings, ten small payload cups, 10 large fused payload cups, twenty payload lids, 37mm bird banger builder kit with 10 plastic 37mm hulls, 100 209 shotgun primers, waterproof cannon fuse and a free 37mm load data booklet. 

Check federal, state and local laws and regulations before constructing any 37mm cartridges. Buyer assumes all risk involved in loaded, reloading constructing and using 37mm cartridges. 

37mm Plastic Bundle - Fused

37mm Reloadables

Price: $35.00

These are our new plastic injected payload carriers, bushings and lids! They are made using injection molding. they are consistent and molded perfect. You get 10 cups, 10 bushings and 10 rounded lids. choose between 2inch or 3 inch and fused or unfused. $5.00 upcharge for fused cups.

Check federal, state and local laws and regulations before constructing any 37mm cartridges. Buyer assumes all risk involved in loaded, reloading constructing and using 37mm cartridges.   

37mm Plastic Bundle - UnFused

37mm Reloadables

Price: $30.00

These are our new plastic injected payload carriers, bushings and lids! They are made using injection molding. they are consistent and molded perfect. You get 10 cups, 10 bushings and 10 rounded lids. choose between 2inch or 3 inch and fused or unfused. $5.00 upcharge for fused cups.

Check federal, state and local laws and regulations before constructing any 37mm cartridges. Buyer assumes all risk involved in loaded, reloading constructing and using 37mm cartridges.   

37mm ASA MOAB

ASA MOAB

Price: $3.75 / $4.75

This fin stabilized projectile comes in three pieces. The fin, mid and nose cone. The nose cone can be loaded with chalk or paint for practice / marker round. You can also load it with an OC powder for an impact tear gas style round. Manufactured by American Specialty Ammo.

This projectile is also available fused. With the fused projectile you will be able to load flare or smoke burst compound. 

For crowd dispersal you can load this round with a mix of black powder and OC powder for an air burst tear gas round. A fog of powder will rain down on the crowd causing very unpleasant reactions. 

Colors will vary. MOABS come in 3 parts for you to put together. These will only work in our 3 inch hulls. The two inch are too short. 

Check federal, state and local laws on regulations before constructing any 37mm cartridges. Buyer assumes all risk involved in loading, reloading, constructing and using 37mm cartridges.  

Bentonite Clay

Price: $4.99 / lb

One pound of bentonite clay. This clay comes as a fine tan powder, once compressed with a hammer it becomes hard as a rock. This clay can be used to plug the end of the 37mm tubes. It can be used in place of the plugs in the smoke bomb builder kit. It ensures a perfect seal. 

209 Primers - 100 ct

209 Primer

Price: $5.00

Box of 100 209 shotgun primers for use with our aluminum hulls, plastic hulls and bird banger kits. 

HAZMAT ITEM

37mm Load Data

Price: Free

Contains information on how to construct and load a variety of rounds. 


This is for informational purpose only. We do not recommend actually constructing any of these rounds. Loading is very dangerous is not done properly. 

Check with the manufacturer of your 37mm device to determine what is safe for your launcher. All launchers ARE NOT created equal. Some rounds are not safe to fire from all devices. 

Constructing, possessing and/or using anti-personnel rounds with an unregistered launcher is prohibited by federal law. Before you construct, possess and/or use any anti personnel rounds you must first register your launcher as a destructive device with the ATF and pay the appropriate tax. 

The ATF does NOT give second chances or slaps on the wrist. You will be found guilty of owning an unregistered destructive device and sentences to a mandatory prison sentence. IGNORANCE OF THE LAW IS NOT AN EXCUSE!

Check federal, state and local laws on regulations before constructing any 37mm cartridges. Buyer assumes all risk involved in loading, reloading, constructing and using 37mm cartridges.